Plasma TorchP80 PLASMA TORCH
Plasma torch P-80
Plasma torch P-80 is designed exclusively for plasma cutting and beveling with compressed air as a plasma-forming and cooling gas for industrial and production use only by specialists. All plasma torches require dry and clean compressed air to operate.
Wearing parts and breakdowns caused by overloading or improper handling are not covered by the warranty.
In this operating manual, the works described are presented in such a way that they can only be understood and carried out by a specialist.
According to EN-60204-1:
Torch connection requirements
Use only compressed air free of dirt, oil and water.
Pay attention to conformity and tightness of the connection.
Set the correct air pressure (flow pressure), ensure that there is sufficient air volume. An insufficient amount of air leads to thermal overheating
Technical Specification:
Plasma torch | |
Type of use | manual |
Control (pilot) current | 15-25A (max. 25A) |
Determination of current and PV compliance | 100A / 60% 80A / 100% |
Gas type | compressed air |
Gas supply | approx. 180 l / min. |
Working (flow pressure) pressure at the entrance to the torch (atm.) | 4,5 – 5,0 |
Material thickness (mm) | |
steel | 35 (max. 40) at 100A, 30 (max. 35) at 90A |
Stainless steel | 30 (max. 35) at 100A, 25 (max. 30) at 90 A |
Aluminum | 25 (max.30) at 100A, 20 (max.25) at 90A |
< Up: PT31 PLASMA TORCH
Next: S75 PLASMA TORCH >
SG51 PLASMA TORCH
S75 PLASMA TORCH
P80 PLASMA TORCH
PT31 PLASMA TORCH
